Identifier Manager Faults
fltUuidpoolPoolEmpty
This fault typically occurs when a uuid pool does not contain any uuids.
If you see this fault, take the following actions:
Step 1
If the pool is in use, add a block of uuids to the pool.
Step 2 If the pool is not in use, ignore the fault.
fltFcpoolInitiatorsEmpty
FC pool [purpose] [name] is empty
This fault typically occurs when a fc pool does not contain any fc.
If you see this fault, take the following actions:
Step 1 If the pool is in use, add a block of fc to the pool.
Step 2 If the pool is not in use, ignore the fault.
fltMacpoolPoolEmpty
This fault typically occurs when a mac pool does not contain any mac.
If you see this fault, take the following actions:
Step 1 If the pool is in use, add a block of mac to the pool.
Step 2 If the pool is not in use, ignore the fault.
fltIdentpoolElementDuplicatedAssigned
This fault typically occurs when duplicate ID is assigned.
If you see this fault, take the following actions:
Step 1 check FC Pool and make sure no duplicate address is assigned.
Step 2 check IP Pool and make sure no duplicate address is assigned.
Step 3 check IQN Pool and make sure no duplicate address is assigned.
Step 4 check MAC Pool and make sure no duplicate address is assigned.
Step 5 check UUID Pool and make sure no duplicate address is assigned.
fltIdentpoolElementDuplicatedDefined
ID is defined in multiple systems
This fault typically occurs when ID is defined in multiple systems.
If you see this fault, take the following actions:
Step 1 check FC Pool and make sure an address is not defined in multiple systems.
Step 2 check IP Pool and make sure an address is not defined in multiple systems.
Step 3 check IQN Pool and make sure an address is not defined in multiple systems.
Step 4 check MAC Pool and make sure an address is not defined in multiple systems.
Step 5 check UUID Pool and make sure an address is not defined in multiple systems.
fltIppoolPoolEmpty
This fault typically occurs when a ip pool does not contain any ip.
If you see this fault, take the following actions:
Step 1 If the pool is in use, add a block of ip to the pool.
Step 2 If the pool is not in use, ignore the fault.
fltIqnpoolPoolEmpty
This fault typically occurs when a iqn pool does not contain any iqns.
If you see this fault, take the following actions:
Step 1 If the pool is in use, add a block of iqns to the pool.
Step 2 If the pool is not in use, ignore the fault.
fltCommSvcEpCommSvcNotDeployed
Communication Service configuration can’t be deployed. Error: [configStatusMessage]
This fault typically occurs because Cisco UCS Manager has detected an invalid communication policy confiuration.
If you see this fault, take the following actions:
Step 1 Verify that ports configured across all communication services is unique.
fltPkiTPStatus
[name] Trustpoint’s cert-chain is invalid, reason: [certStatus].
This fault occurs when certificate status of TrustPoint has become invalid.
If you see this fault, take the following actions:
Step 1 Identify the Trustpoint(s) affected.
Step 2 For affected trust-points, delete those keyrings using this trustpoint. Obtain new CA certificate and install.
fltPkiKeyRingStatus
[name] Keyring’s certificate is invalid, reason: [certStatus].
This fault occurs when certificate status of Keyring has become invalid.
If you see this fault, take the following actions:
Step 1 Identify the keyring(s) affected.
Step 2 If default keyring certificate is affected, regenerate the certificate.
Step 3 For other keyrings create new cert-req and get it signed by CA and set to keyring.
Feedback