Mesh Support Overview
From Cisco IOS XE 17.15.1 release, the IW9167IH AP supports bridge or flex+bridge modes, extending the wireless network through mesh backhaul that supports both 2.4 GHz and 5 GHz frequencies.
Note |
Disable the 6 GHz radio before configuring the IW9167IH APs in bridge or flex+bridge mode. Enable the 6 GHz radio only when the IW9167IH APs are not in bridge or flex+bridge mode. |
This feature helps transition quickly between bridge or flex+bridge modes. When you run the #ap name IW9167IAP mode bridge
command, the AP automatically reboots and transitions to either bridge or flex+bridge mode.
Note |
When issuing the |
In bridge mode, APs wirelessly form either a point-to-point or point-to-multipoint bridge. This setup allows APs in bridge mode to connect to different locations. Moreover, several APs can form a mesh network, which can be either indoor or outdoor.
The flex+bridge mode enables FlexConnect capabilities on mesh (bridge mode) APs.
For information on configuring mesh on Catalyst 9800 Wireless Controllers, see the Configure Mesh on Catalyst 9800 Wireless LAN Controllers.