Contents

Introduction

Prerequisites

Requirements

Components Used

Configure

From Cisco DNAC GUI:

Provisioning C9800 via Cisco DNAC

Step 1: Design

Step 2: Provisioning

Troubleshoot

Introduction

This document describes how to add, manage, and provision non-fabric Catalyst 9800 Wireless LAN Controllers via Cisco DNA Center (DNAC).

Prerequisites

Basic knowledge of Catalyst 9800 and Cisco DNA Center configuration.

Requirements

Refer to software compatibility matrix for solution compatibility requirements on Catalyst 9800 WLC and Cisco DNA Center.

Components Used

- 9800-CL on 16.12.4a release

- Cisco DNAC on 2.1.2.0 release

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, ensure that you understand the potential impact of any command.

Configure

From Cisco DNAC GUI:

1. Log into Cisco DNAC GUI.

2. On the top left corner of the webpage, click the hamburger menu, click Tools, and then click Discovery:

Note: You can alternatively discover your C9800 device using the Inventory menu.

3. On the Discovery page, click Add Discovery:

4. Enter the C9800 WLC details.

Scroll down to enable the CLI/SNMP/HTTP/HTTPS credentials:

Note: The username/password/SSHv2 needs to be configured on the device first.

To enable NETCONF on the Discovery page:

Note: The default NETCONF port on C9800 is port 830.

Then press the Discover button and press the Start button:

Note: You can schedule the Discovery process for a different time and date.

If everything got configured correctly on Cisco DNA Center and on the 9800 WLC, then the Discovery can end up looking similar to this:

Make sure to validate that the device is in a Managed state in the Inventory page:

C9800 is now added to Cisco DNAC.

Provisioning C9800 via Cisco DNAC

Step 1: Design

1. From the Cisco DNAC home page, click the Design tab.

A site map and floor plan has already been added to the Network Hierarchy tab.

2. To add Wireless SSID, click the Network Settings tab and navigate to Wireless and then click Add.

Scroll down to access security settings and configure PSK password.

Click the Next tab to bring you to the Wireless Profiles tab where you configure your wireless profile to be assigned to the specific site.

Click the Finish button to add both the WLAN and Wireless Policy profiles you just created.

Step 2: Provisioning

Now that the WLAN and profiles have been designed, you can provision them to the respective WLCs. For this, click the Provision tab on the top of Cisco DNAC.

1. On the Provision menu, you can filter for your device name under device inventory Filter option.

2. Select your WLC and hover over the Actions field and navigate to Provision.

3. Add device to your site.

4. In this example, AP and WLC are in same location. You can skip past the configuration and advanced configuration step here and deploy from the summary page.

Validate if the provisioning was successful:

5. Next step is to provision your Access Point using same method as above.

6. You can now validate the provisioning status from C9800, navigate to GUI > Configurations > WLAN.

You have now successfully provisioned WLC/AP via Cisco DNAC.

Troubleshoot

From Cisco DNACsudo rca from the CLI of each Cisco DNAC in the cluster;

From C9800 CLI:

Debugs:

debug snmp requests

debug snmp packets

debug netconf-yang level debug

show platform software yang-management process

Verifies whether all the processes are running.

If netconf-yang is running, all the processes except gnmib are UP state.